新买来一个remoter
在网上搜到了如下的给remoter programming的instruction
1. Make sure ignition is in the OFF position.
2. Locate the Programming Connector in the trunk (driver’s side). It is a plastic connector with two wires leading up to it. The connector is not plugged into anything. You may have to pull back trim to access the connector.
3. The programming connector should have two terminals. Connect both terminals with a suitable jumper wire. Make sure the terminals remain connected throughout the programming procedure.
4. Press the LOCK and UNLOCK buttons on the transmitter simultaneously. In response, the Keyless Entry Module will cycle all the Door Lock Motors at once. Your new remote has been accepted and all existing remote codes have been erased.
5. Repeat the previous step for each additional transmitter (including any existing transmitters). Do not remove jumper wire in between programming of transmitters.
6. Remove the jumper wire from the Keyless Programming Connector.
有几个地方看不明白 请各位老司机帮看一下
1. Locate the Programming Connector in the trunk (driver’s side)
这个指的是哪里？ 有的网站上说是the two wire connector plugged into the RKE reciever in the trunk of the vehicle at the Left Wheelhouse
是说的后背箱还是驾驶室的某个位置？
偶的后背箱没有remoter打不开
2. jumper wire是啥？普通的电线可以么？
先行谢过了
